Gw-instek PSU-Series Programming User Manual Instrukcja Użytkownika Pobierz pdf (Strona 43)

REMOTE CONTROL

4. Terminate the OUT port of the last unit with

the end terminal connector included in the

PSU-232 or PSU-485 connection kit.

5. Press the Function key to enter the

Normal configuration settings for

the master unit.

Page 21

Set the following settings:

F-70 = 1 or 2

Configure the master unit as you

normally would for RS232 or

RS485 remote control.

F-71 = 0~7

Set the baud rate (set all units

the same).

F-72 = 1

Set to 8 data bits.

F-73 = 0

Parity to none.

F-74 = 1

1 Stop bit.

F-75 = 1

Set the UART TCP to TDK

(emulation mode).

F-76 = 00~31

Set the address of the master

unit. It must be a unique

address identifier.

6. Press the Function key to enter the

Normal configuration settings for

the slave(s).

Page 21

Set the following settings:

F-70 = 2

Set the slave unit to RS485.

F-71 = 0~7

Set the baud rate (make all

units, including the master, the

same baud).

F-72 = 1

Set to 8 data bits.

F-73 = 0

Parity to none.

F-74 = 1

1 Stop bit.

F-75 = 1

Set the UART TCP to TDK

(emulation mode).

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 127 128

Komentarze do niniejszej Instrukcji

Brak uwag

Gw-instek PSU-Series Programming User Manual Instrukcja Użytkownika Strona 43

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Ekwipunek Gw-instek PSU-Series Programming User Manual