Gw-instek APS-1102 Control Software User Manual Instrukcja Użytkownika Pobierz pdf (Strona 71)

APS-1102A Control Software User Manual

7.8.4 Waveform Function Setting

When [Function] is selected in Select a Waveform (

7.8.2), constant input section [Constant] and

formula input section [Y=] are displayed.

Figure 7-9 When "Waveform Function" is Selected

By entering constant and formula and clicking Execute button, you can check the calculated waveform

in waveform display area of [New Arbitrary Waveform Editing Panel].

Constant

Constant is described as [constant = value or formula] format, for example, [fs=32767;],

[s=2*pi/4096;]. Always add semicolon [;] at the end of a constant definition or formula.

A constant or formula is described in single-byte. Alphabetical characters are case-independent.

Any constant should start with an alphabetical character and consist of alphanumeric characters.

Name of a constant should not be same as any of the embedded functions (

Table 7-5). It is also

recommended to avoid using the same string as one of the embedded constants (

Table 7-3).

With the All-Page OK button, constant is effective for all pages on and after the defined page.

For example, constants defined on page 1 are effective for all the pages. Constants defined on page 3 are

not effective for page 1 and 2, but effective for page 3 and after.

When creating only the waveforms that are displayed by the Page OK button, constants are effective

only for pages being displayed. For example, constants defined on page 2 are not effective for page 1 or

pages on and after 3.

In this case, to make the constant given on other page effective, click Execute button on the page

where the constant is defined to perform a calculation beforehand.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 95 96

Brak uwag

Gw-instek APS-1102 Control Software User Manual Instrukcja Użytkownika Strona 71